AMSWWT700_5B

__________________________________________________________________________________________________________________________________________ SAE Technical Standards Board Rules provide that “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be revised, reaffirmed, stabilized, or cancelled. SAE invites your written comments and suggestions. Copyright 2018 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retri system or transmitted, in any or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER Tel 877-606-7323 inside USA and Canada Tel 1 724-776-4970 outside USA Fax 724-776-0790 Email CustomerServicesae.org SAE WEB ADDRESS http//www.sae.org SAE values your . To provide feedback on this Technical Report, please visit http//standards.sae.org/AMSWWT700/5B AEROSPACE MATERIAL SPECIFICATION AMS-WW-T-700/5 REV. B Issued 2001-07 Noncurrent 2007-09 Reaf. Nonc. 2012-09 Stabilized 2018-02 Superseding AMS-WW-T-700/5A Tube, Aluminum Alloy, Drawn, Seamless, 5086 RATIONALE AMS-WW-T-700/5B stabilizes this document because it is no longer state of the art and other documents contain similar but not necessarily equivalent requirements. STABILIZED NOTICE AMS-WW-T-700/5B has been declared STABILIZED by SAE AMS Committee D Nonferrous Alloys. This document will no longer be updated and may no longer represent standard industry practice. This document was stabilized because it is no longer state of the art and other documents contain similar but not necessarily equivalent requirements. Previously this document was non-current. This document has never been technically reviewed. Users of this document should refer to the cognizant engineering organization for disposition of any issues with reports/certifications to this specification; including exceptions listed on the certification. NOTE In many cases, the purchaser may represent a sub tier supplier and not the cognizant engineering organization. AMS Committee D recommends that the following similar but not identical specifications may be considered for future procurement. This listing does not constitute authority to substitute these specifications for the “STABILIZED” specification. ASTM B210 Aluminum and Aluminum Alloy Drawn Seamless Tubes - designating alloy 5086 and applicable temper SAE INTERNATIONAL AMS-WW-T-700/5B Page 1 of 6 SAE INTERNATIONAL AMS-WW-T-700/5B Page 2 of 6 SAE INTERNATIONAL AMS-WW-T-700/5B Page 3 of 6 SAE INTERNATIONAL AMS-WW-T-700/5B Page 4 of 6 SAE INTERNATIONAL AMS-WW-T-700/5B Page 5 of 6 SAE INTERNATIONAL AMS-WW-T-700/5B Page 6 of 6